When it's right, drive screws through the adjacent face frame into the edge of the filler board. Remove the board and cut along the scribe line with a jig saw, then reinstall it to check the fit. Clamp the board to the end cabinet's face frame, then trace the wall contour with the compass. Start by setting a marking compass to the width of the gap, then place a strip of 1"-wide masking tape along the filler board in the area where it needs to be trimmed. If the wall is irregular, you'll have to scribe-fit the filler board. If the wall is flat, simply rip the filler board to the required width and fasten it in place.
#Cabinet scribe strip holder clamp install
Then install and fasten the last cabinet and measure the gap between its face frame and the wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. There is no right or wrong way to start, I just prefer to start with the upper cabinets first. Some people start with the base cabinets, but we are going to start with the wall cabinets first. Now that the kitchen cabinets are assembled, we are ready to start marking out our layout lines. In this case we bought (RTA) Ready-To-Assemble Kitchen Cabinets from RTA Kitchen & Bathroom Cabinet Store. In either case, you will need another set of hands to help with the installation. If you plan on installing more than one kitchen, then I would suggest the frame, but a piece of lumber will do just fine if this is a one time event. This can be made out of 2' x 4's and should be tall enough to support the bottom of your wall cabinets. Screws (long enough to go 1 1/2 into the studs)Īn extra set of hands (you may have to bribe one of your friends)Īs I mentioned above, you have the option of using a piece of 1' x 3' lumber for the installation or building a u-shaped frame to support the wall cabinets (see the picture below). Before we get started there are a couple of items that you will need for the project:ġ" x 3" Piece of lumber (6'-8' in length) or an Inverted U-shaped frame (see notes below)
By placing layout markings on the walls and floors, it will not only help you with kitchen cabinet placement and stud locations, but it will also help you locate where adjustments and shims will be required. While the actual installation of the Kitchen Cabinets isn't all that hard, the critical first step is measuring and marking out where the cabinets will go. Now that you have your new RTA kitchen cabinets, you are ready to move on to the next big step.Installing your kitchen cabinets. RTA Kitchen Cabinets: Step-by-Step Installation Instructions Keep checking back for more instructional videos or subscribe to our YouTube channel:
#Cabinet scribe strip holder clamp how to
There is also an instructional video on how to install your upgraded drawer slides for some of our cabinets. Here are a few videos put together to show you what you will be facing when you open up your first RTA Wall and or Base.
L Bracket Installation Instructions for Standard Wall Cabinets SW.Assembly Instructions 2 Piece Pantry SW.Kitchen Blind Corner Base Cabinet Assembly.
0 kommentar(er)
